Lutron RadioRA2 Plug-In Dimmer Module (snow white)

RR-3PD-1-SW

On a single-tap of the toggle button, lights fade On or Off
On a double-tap of the toggle button, lights go to full On
When On, press and hold the toggle button to engage the delayed long fade to Off
Light levels can be fine-tuned by pressing and holding the raise/lower buttons until the desired light level is reached
Control non-dimmable lighting loads in switching mode
Power: 120 V 50/60 Hz
Typical power consumption: 0.3 W, test conditions: load is off
Regulatory approvals: cUL, UL, FCC, IC, SCT, NOM (-3PD only; -15APS pending)
Environment: ambient operating temperature: 32°F to 104°F (0°C to 40°C), 0% to 90% humidity, non-condensing. Indoor use only
Communications: plug-in modules communicate with the system through Radio Frequency (RF) and must be located within 30' (9m) of a repeater. System devices operate on frequencies between 431.0 MHz and 437.0 MHz
ESD protection: tested to withstand electrostatic discharge without damage or memory loss, in accordance with IEC 61000-4-2
Surge protection: tested to withstand surge voltages without damage or loss of operation, in accordance with IEEE C62.41-1991 Recommended Practice on Surge Voltages in Low-Voltage AC Power Circuits
Power failure memory: should power be interrupted, the RF Plug-In Module will return to its previous state when power is restored
Warranty: 1 year limited warranty